GeoKnight DC8AP Press - Hats
This FabricForm instruction sheet was developed using a GeoKnight DC16AP with a bottom heat platen. Since every heat press is slightly different, we recommend testing the heat & time on your specific press.
Instructions For Applying Emblems on Hats
1
Heat setting: 350 degrees
Pressure: 40 PSI
2
Flip open the sweatband of the hat.
3
Place the hat on the bottom heat platen so that the sweatband is just below the edge of the platen.
4
Remove the liner from the back of the emblem.
5
6
Place your Fabric-Form logo on the hat.
Lay the silicone pad on top of the emblem so that the emblem is centered under the pad and is completely covered.
7
Heat your emblem. Start with 45 seconds. Depending on your machine and the material of the hat, you may need to adjust the time.
8
Remove the hat from the heat press and allow it to cool for 15-20 seconds. Slowly peel back the protective film from the emblem at a sharp angle.